Welcome, Guest
Username: Password:
SAR1906 SH2015 building model

TOPIC: Testing of lasercut model version 0.5

Testing of lasercut model version 0.5 3 years 6 months ago #2

Testing of model version 0.5 is in progress. We started building a SH2015 version 0.5 at Intermodellbau Dortmund.

Some minor flaws are found so far, read the following postings for proper corrections.
StevenH
Last Edit: 3 years 6 months ago by Steven.
The administrator has disabled public write access.

Testing of lasercut model version 0.5 -List of flaws in drawing 3 years 6 months ago #5

sofar (2015-04-21) all flaws found can be easily manually adjusted.

Rafters are counted from the back of the keel.
Rafter zero is the rafter with the 27mm holes for the jets.
Rafter minus 2 is the last rafter at the backside of the ship (2 parts, connected with a 3mm temporary joint.

From version 0.5 the kit includes rafters -2,-1,0, 3,6,8,9,11,13,15,16.

The other rafters are obsolete, you don't need them and from version 0.5 they are not included. This saves weight which is a big factor when building this model.

FLAWS VERSION 0.5
-rafter -2 has a too low keep on the upper left side. Raise it by 3 mm.
-rafter -2 should have the same keep on the right upper side. Add this keep.

-rafter 6 has a too shallow keep. File the keep for the keel some 3 mm deeper.
(rafter 6 is the rafter with the motor base)

Build version 0.6 will be assembled for delivery coming week(18).
Mentioned flaws will be corrected in version 0.6.
StevenH
The administrator has disabled public write access.

Testing of lasercut model version 0.5 3 years 5 months ago #12

Today the hull was closed. The bow part has been planked in sections to find out the exact form of the forward rafters

Attachment IMGA0856kl.jpg not found




Attachment IMG_0364kl.jpg not found

StevenH
Last Edit: 3 years 5 months ago by Steven.
The administrator has disabled public write access.
Powered by Kunena Forum